Cedardell Ltd. Home central locking - secure radio communications

	Step 1; Remove the BoltMaster control unit and any BoltOn units from their carriers. Press and hold the tamper switch on the BoltMaster control while you fit the battery, now release the tamper switch and the unit will give a single beep and turn its LED on.
Install Key-fobs as follows; Press and hold both key-fob buttons until the LED comes on and goes out again then release the buttons. When installed the LED will give three flashes and the Master Unit will give a single beep. Repeat for all other key fobs
	Install any BoltOn units as follows: Fit the battery into the BoltOn unit being commissioned When installed the LED will give three flashes and the Master Unit will give a single beep Return the BoltOn unit on its carrier Repeat this until all BoltOn units have been commissioned
Exit Installation mode to finish: Place the BoltMaster unit back on its carrier The master unit will switch off its LED and give a single beep Test the system by carrying out a number of locks and unlocks, ensuring that the bolts are fully thrown and retracted.